Command Line Reference Guide

File Management | 41
Defaults
None.
Command Mode
EXEC Privilege
Command
History
Example
Command example: restore fpga-image
Usage
Information
Reset the card using the power-cycle option after restoring the FPGA command.
Related
Commands
show boot system
c e
Displays information about boot images currently configured on the system.
Syntax
show boot system {all | linecard [slot | all] | rpm | stack-unit [0-11 | all]}
Parameters
Defaults
No default values or behavior
Version 7.7.1.0
Renamed keyword
primary-fpga-flash to fpga-image.
Version 7.5.1.0 Introduced on C-Series
Force10#restore fpga-image linecard 4
Current FPGA information in the system:
=======================================
Card FPGA Name Current Version New Version
------------------------------------------------------------------------
LC4 48 Port 1G LCM FPGA A: 3.6 restore
***********************************************************************
* Warning - Upgrading FPGA is inherently risky and should *
* only be attempted when necessary. A failure at this upgrade may *
* cause a board RMA. Proceed with caution ! *
***********************************************************************
Restore fpga image for linecard 4 [yes/no]: yes
FPGA restore in progress. Please do NOT power off the card.
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Upgrade result :
================
Linecard 4 FPGA restore successful.
reset Reset a card.
all
Enter this keyword to display boot image information for all linecards and
rpms.
linecard
Enter this keyword to display boot image information for the specified
linecard(s) on the system.
rpm
Enter this keyword to display boot image information for all rpms on the
system.
stack-unit
Enter this keyword to display boot image information for one or all the S55
units.