Command Line Reference Guide

Content Addressable Memory (CAM) | 385
Usage
Information
You must save the running configuration using the command copy running-config startup-config
after changing the CAM profile from CONFIGURATION mode. CAM profile changes take effect after
the next chassis reboot.
show cam-acl
c
Display the details of the CAM profiles on the chassis and all line cards.
Syntax
show cam-acl
Defaults
None
Command Modes
EXEC Privilege
Command
History
Usage
Information
The display reflects the settings implemented with the cam-acl command.
Example
Figure 10-1. Command Output: show cam-acl (default)
Version 7.4.2.0 Added the unified-default CAM profile and lag-hash-align microcode
Version 7.4.1.0 Added the lag-hash-mpls microcode
Version 6.5.1.0 Added the eg-default and ipv4-320k CAM profiles
Version 6.3.1.0 Introduced on E-Series
Note: Do not use the ipv4-egacl-16 CAM profile for Layer 2 egress ACLs.
Note: Do not make any changes to the CAM profile after you change the profile to
ipv4-320K and save the configuration until after you reload the chassis; any changes lead to
unexpected behavior. After you reload the chassis, you may make changes to the IPv4 Flow
partition.
Version 7.8.1.0 Introduced on C-Series
Force10#show cam-acl
-- Chassis Cam ACL --
Current Settings(in block sizes)
L2Acl : 5
Ipv4Acl : 6
Ipv6Acl : 0
Ipv4Qos : 1
L2Qos : 1
-- Line card 4 --
Current Settings(in block sizes)
L2Acl : 5
Ipv4Acl : 6
Ipv6Acl : 0
Ipv4Qos : 1
L2Qos : 1
Force10#