Command Line Reference Guide

380 | Bare Metal Provisioning
www.dell.com | support.dell.com
stop jump-start
z
Stop the switch from reloading in Jumpstart mode to prevent an infinite loop.
Syntax
stop jump-start
Defaults
None
Command Modes
EXEC Privilege
Command
History
Related
Commands
Usage
Information
Use the stop jump-start command from the console of a switch running BMP 2.0 if the switch
enters a loop while reloading in Jumpstart mode; loop occurs when the switch is continuously
trying to contact a DHCP server and a DHCP server is not found. The
stop jump-start
command stops the switch from connecting to the DHCP server. After the
stop jump-start
command is used, the next default reload type will be a normal reload. This will be indicated
in the
show reload-type command.
Version 8.3.5.3 Introduced on S55.
Version 8.3.3.8 Introduced on S60.
Version 8.3.11.4 Introduced on Z9000
Version 8.3.10.1 Introduced on S4810.
reload-type Configure the reload mode as normal or Jumpstart.