Command Line Reference Guide

Bare Metal Provisioning | 379
Use the reload-type command in BMP 2.0 to toggle between Normal and Jumpstart
auto-configuration modes. The reload settings for the auto-configuration mode that you
configure are stored in memory and retained for future reboots and BMP software upgrades.
You can enter the
reload command at any time to reload the switch in the last configured
mode: Normal reload or Jumpstart mode.
Related
Commands
show reload-type
z
Display the currently configured reload mode.
Syntax
show reload-type
Defaults
None
Command Modes
EXEC Privilege
Command
History
Usage
Information
Use the show reload-type command to check the currently configured auto-configuration
mode (Jumpstart or Normal reload) on a switch running BMP 2.0.
You can also use the
show bootvar command to display the current reload mode for BMP 2.0
with the path of the FTOS image file retrieved from a DHCP server.
Example FTOS#show reload-type
Reload-Type : normal-reload [Next boot : normal-reload]
Related
Commands
show reload-type Display the current reload mode (Normal or jump-start mode)
stop jump-start Stops the Jumpstart process to prevent a loop if the DHCP server
is not found.
Version 8.3.5.3 Introduced on S55.
Version 8.3.3.8 Introduced on S60.
Version 8.3.11.4 Introduced on Z9000
Version 8.3.10.1 Introduced on S4810.
reload-type Configure the reload mode as normal or Jumpstart.