Command Line Reference Guide

356 | Border Gateway Protocol IPv4(BGPv4)
www.dell.com | support.dell.com
Defaults
Not configured.
Command Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Usage
Information
If you do not configure default-metric command, in addition to the redistribute command, or there is no
route map to set the metric, the metric for redistributed static and connected is “0”.
To redistribute the default route (0.0.0.0/0) configure the neighbor default-originate command.
Related
Commands
Command
History
redistribute ospf
c e
t
s
Redistribute OSPF routes into BGP.
Syntax
redistribute ospf process-id [[match external {1 | 2}] [match internal]] [route-map
map-name]
To stop redistribution of OSPF routes, use the no redistribute ospf process-id command.
Parameters
Defaults
Not configured.
static Enter the keyword static to redistribute manually configured routes.
These routes are treated as incomplete routes.
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of an established
route map.
Only the following ROUTE-MAP mode commands are supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to drop all routes).
neighbor default-originate Inject the default route.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.6.1.0 Introduced IPv6 MGBP support for E-Series
process-id
Enter the number of the OSPF process.
Range: 1 to 65535
match external
{
1 | 2}
(OPTIONAL) Enter the keywords match external to redistribute OSPF external routes.
You can specify 1 or 2 to redistribute those routes only.
match internal (OPTIONAL) Enter the keywords match internal to redistribute OSPF internal
routes only.
route-map
map-name
(OPTIONAL) Enter the keywords
route-map followed by the name of a configured
Route map.