Command Line Reference Guide

Border Gateway Protocol IPv4(BGPv4) | 355
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP Address Family (conf-router_bgp_af)
Usage
Information
FTOS
resolves the network address configured by the network command with the routes in the main
routing table to ensure that the networks are reachable via non-BGP routes and non-default routes.
Related
Commands
Command
History
redistribute
c e
t
s
Redistribute routes into BGP.
Syntax
redistribute [connected | static] [route-map map-name]
To disable redistribution, use the no redistribution [connected | static] [route-map map-name]
command.
Parameters
ip-address
Enter an IP address in dotted decimal format of the network.
mask
Enter the mask of the IP address in the slash prefix length format (for example, /24).
The mask appears in command outputs in dotted decimal format (A.B.C.D).
route-map
map-name
(OPTIONAL) Enter the keyword route-map followed by the name of an established route
map.
Only the following ROUTE-MAP mode commands are supported:
• match ip address
• set community
• set local-preference
• set metric
• set next-hop
• set origin
• set weight
If the route map is not configured, the default is deny (to drop all routes).
redistribute Redistribute routes into BGP.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.6.1.0 Introduced IPv6 MGBP support for E-Series
connected Enter the keyword connected to redistribute routes from physically connected
interfaces.