Command Line Reference Guide

306 | Border Gateway Protocol IPv4(BGPv4)
www.dell.com | support.dell.com
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Usage
Information
When you apply a route map to outbound routes, only routes that match at least one section of the route
map are permitted.
If you identify a peer group by name, the peers in that peer group inherit the characteristics in the
Route map used in this command. If you identify a peer by IP address, the Route map overwrites either
the inbound or outbound policies on that peer.
Command
History
neighbor route-reflector-client
c e s
Configure a neighbor as a member of a route reflector cluster.
Syntax
neighbor {ip-address | peer-group-name} route-reflector-client
To indicate that the neighbor is not a route reflector client or to delete a route reflector configuration,
use the no neighbor {ip-address | peer-group-name} route-reflector-client command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Usage
Information
The first time you enter this command it configures the neighbor as a route reflector and members of
the route-reflector cluster. Internal BGP (IBGP) speakers do not need to be fully meshed if you
configure a route reflector.
When all clients of a route reflector are disabled, the neighbor is no longer a route reflector.
Command
History
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group.
map-name
Enter the name of an established route map.
If the Route map is not configured, the default is deny (to drop all routes).
in Enter the keyword in to filter inbound routes.
out Enter the keyword out to filter outbound routes.
Version 8.3.5.0 Introduced on the S55.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name Enter the name of the peer group.
All routers in the peer group receive routes from a route reflector.
Version 8.3.5.0 Introduced on the S55.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series