Command Line Reference Guide

298 | Border Gateway Protocol IPv4(BGPv4)
www.dell.com | support.dell.com
neighbor filter-list
c e s
Configure a BGP filter based on the AS-PATH attribute.
Syntax
neighbor {ip-address | peer-group-name} filter-list as-path-name {in | out}
To delete a BGP filter, use the no neighbor {ip-address | peer-group-name} filter-list
as-path-name
{in | out} command.
Parameters
Defaults
Not configured.
Command Modes
ROUTER BGP
Usage
Information
Use the ip as-path access-list command syntax in the CONFIGURATION mode to enter the AS-PATH
ACL mode and configure AS-PATH filters to deny or permit BGP routes based on information in their
AS-PATH attribute.
Related
Commands
Command
History
neighbor graceful-restart
c e s
Enable graceful restart on a BGP neighbor.
Syntax
neighbor {ip-address | peer-group-name} graceful-restart [restart-time seconds]
[stale-path-time seconds] [role receiver-only]
To return to the default, enter the no bgp graceful-restart command.
Parameters
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group to apply the filter to all routers in the
peer group.
as-path-name
Enter the name of an established AS-PATH access list (up to 140
characters).
If the AS-PATH access list is not configured, the default is permit (allow
routes).
in Enter the keyword in to filter inbound BGP routes.
out Enter the keyword out to filter outbound BGP routes.
ip as-path access-list Enter AS-PATH ACL mode and configure AS-PATH filters.
Version 8.3.5.0 Introduced on the S55.
Version 7.8.1.0 Introduced support on S-Series
Increased name string to accept up to 140 characters. Prior to 7.8.1.0, ACL names are up
to 16 characters long.
Version 7.7.1.0 Introduced support on C-Series
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group to apply the filter to all routers in the
peer group.