Command Line Reference Guide

Border Gateway Protocol IPv4(BGPv4) | 283
Usage
Information
When soft-reconfiguration is enabled for a neighbor and the clear ip bgp soft in is executed, the
update database stored in the router is replayed and updates are reevaluated. With this command, the
replay and update process is triggered only if route-refresh request is not negotiated with the peer. If
the request is indeed negotiated (upon execution of clear ip bgp soft in), then BGP sends a
route-refresh request to the neighbor and receives all of the peer’s updates.
Related
Commands
Command
History
capture bgp-pdu neighbor
c e s
Enable capture of an IPv4 BGP neighbor packet.
Syntax
capture bgp-pdu neighbor ipv4-address direction {both | rx | tx}
To disable capture of the IPv4 BGP neighbor packet, use the no capture bgp-pdu neighbor
ipv4-address command.
Parameters
Defaults
Not configured.
Command Modes
EXEC Privilege
Related
Commands
Command
History
Note: This command is supported in BGP Router Configuration mode for IPv4 Unicast
address only.
clear ip bgp soft in Activate inbound policies without resetting the BGP TCP session.
Version 8.3.5.0 Introduced on the S55.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.2.1.0 Introduced
ipv4-address Enter the IPv4 address of the target BGP neighbor.
direction {both | rx | tx}
Enter the keyword direction and a direction— either rx for
inbound,
tx for outbound, or both.
capture bgp-pdu max-buffer-size Specify a size for the capture buffer.
show capture bgp-pdu neighbor Display BGP packet capture information
Version 8.3.5.0 Introduced on the S55.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.5.1.0 Introduced