Command Line Reference Guide

254 | Access Control Lists (ACL)
www.dell.com | support.dell.com
If you configure the set next-hop command with the interface’s (either Loopback or physical) IP
address, the software declares the route unreachable.
Related
Commands
set origin
c e s
Configure a filter to manipulate the BGP ORIGIN attribute.
Syntax
set origin {igp | egp | incomplete}
To delete an ORIGIN attribute setting, enter no set origin.
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
Command
History
set tag
c e s
Configure a filter to specify a tag for redistributed routes.
Syntax
set tag tag-value
To delete a setting, enter no set tag.
Parameters
Defaults
Not configured
Command Modes
ROUTE-MAP
Command
History
match ip next-hop Redistribute routes that match the next-hop IP address.
neighbor next-hop-self Configure the routers as the next hop for a BGP neighbor.
egp Enter the keyword egp to set routes originating from outside the local AS.
igp Enter the keyword igp to set routes originating within the same AS.
incomplete Enter the keyword incomplete to set routes with incomplete routing information.
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
pre-Version 6.1.1.0 Introduced for E-Series
tag-value
Enter a number as the tag.
Range: zero (0) to 4294967295.
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Support added for S-Series