Command Line Reference Guide

240 | Access Control Lists (ACL)
www.dell.com | support.dell.com
Set clause with Continue clause
If the route-map entry contains sets with the continue clause, then set actions is performed first
followed by the continue clause jump to the specified route map entry.
• If a set actions occurs in the first route map entry and then the same set action occurs with a
different value in a subsequent route map entry, the last set of actions overrides the previous set of
actions with the same set command.
• If set community additive and set as-path prepend are configure, the communities and AS
numbers are pre-pended.
Related
Commands
description
c e s
Add a description to this route map.
Syntax
description {description}
To remove the description, use the no description {description} command.
Parameters
Defaults
No default behavior or values
Command Modes
ROUTE-MAP
Command
History
Related
Commands
match as-path
c e s
Configure a filter to match routes that have a certain AS number in their BGP path.
Syntax
match as-path as-path-name
To delete a match AS path filter, use the no match as-path as-path-name command.
Parameters
Defaults
Not configured.
Command Modes
ROUTE-MAP
set community Specify a COMMUNITY attribute
set as-path Configure a filter to modify the AS path
description
Enter a description to identify the route map (80 characters maximum).
Version 8.3.5.0 Introduced on the S55.
Version 8.1.1.0 Introduced on E-Series ExaScale
pre-Version 7.7.1.0 Introduced
route-map Enable a route map
as-path-name
Enter the name of an established AS-PATH ACL, up to 140 characters.