Command Line Reference Guide

S55 u-Boot | 169

S55 u-Boot

Overview

All commands in this chapter are in u-Boot. These commands are supported on the only.

To access this mode, hit any key when the following line appears on the console during a system boot:

Hit any key to stop autoboot:

You enter u-Boot immediately, as indicated by the => prompt.

Commands

• nvram

• printenv

• reset

• save

• setenv

Note: This chapter discusses only a few commands available in uBoot. The commands

included here are those that are comparable to those found in the Boot User mode on other

S-Series systems.

Note: You cannot use the Tab key to complete commands in this mode.