Command Line Reference Guide

S-Series Debugging and Diagnostics | 1087
Usage
Information
This command enables a hardware watchdog mechanism that automatically reboots an FTOS switch/
router with a single unresponsive unit. This is a last resort mechanism intended to prevent a manual
power cycle.
show hardware layer2 acl
s
Display Layer 2 ACL data for the selected stack member and stack member port-pipe.
Syntax
show hardware layer2 acl stack-unit id port-set 0-1
Parameters
Defaults
No default behavior
Command Modes
EXEC Privilege
Command
History
show hardware layer3
s
Display Layer 3 ACL or QoS data for the selected stack member and stack member port-pipe.
Syntax
show hardware layer3 {acl | qos} stack-unit id port-set 0-1
Parameters
Defaults
No default behavior
Command Modes
EXEC Privilege
Command
History
stack-unit id Enter the keyword stack-unit to select a stack ID.
Unit ID range:
S55: 0-11
all other S-Series: 0-7
port-set 0-1
Enter the keyword port-set with a port-pipe number — 0 or 1. The S25 models of
the S-Series have only port-pipe 0.
Version 8.3.5.0 Introduced on the S55.
Version 7.8.1.0 Introduced on S-Series
acl | qos Enter either the keyword acl or the keyword qos to select between ACL or
QoS data.
stack-unit id
Enter the keyword stack-unit to select a stack ID.
Unit ID range:
S55: 0-11
all other S-Series: 0-7
port-set 0-1
Enter the keyword port-set with a port-pipe number — 0 or 1. The S25
models of the S-Series have only port-pipe 0.
Version 8.3.5.0 Introduced on the S55.
Version 7.8.1.0 Introduced on S-Series