Command Line Reference Guide

1086 | S-Series Debugging and Diagnostics
www.dell.com | support.dell.com
Command
History
Related
Commands
clear hardware system-flow
s
Clear system-flow statistics from selected hardware components.
Syntax
clear hardware system-flow layer2 stack-unit id port-set 0-1 counters
Parameters
Defaults
No default behavior or values
Command Modes
EXEC Privilege
Command
History
Related
Commands
hardware watchdog
s
Set the watchdog timer to trigger a reboot and restart the system.
Syntax
hardware watchdog
Defaults
Enabled
Command Mode
CONFIGURATION
Command
History
Version 8.3.5.0 Introduced on the S55.
Version 7.8.1.0 Introduced on S-Series
show hardware stack-unit Display the data plane or management plane input and output statistics of the
designated component of the designated stack member.
stack-unit id Enter the keyword stack-unit to select a particular stack member and then
enter one of the following command options to clear a specific collection of
data.
Unit ID range:
S55: 0-11
all other S-Series: 0-7
port-set 0–1 counters Enter the keyword port-set along with a port-pipe number, from 0 to 1,
followed by the keyword counters to clear the system-flow counters on
the selected port-pipe.
Note: S25 models (S25N, S25P, S25V, etc.) have only port-pipe 0.
Version 8.3.5.0 Introduced on the S55.
Version 7.8.1.0 Introduced on S-Series
show hardware stack-unit Display the data plane or management plane input and output statistics of the
designated component of the designated stack member.
Version 8.3.5.0 Introduced on the S55.
Version 7.8.1.0 Introduced