Command Line Reference Guide

S-Series Debugging and Diagnostics | 1077
46
S-Series Debugging and Diagnostics
This chapter contains three sections:
• Diagnostics and Monitoring Commands
• Offline Diagnostic Commands
• Buffer Tuning Commands
Diagnostics and Monitoring Commands
For similar commands, see also Chapter 4, Control and Monitoring.
logging coredump server
s
Enable the S-Series to send application core dumps to an FTP server.
Syntax
logging coredump server server username username password [type] password
To disable core dump logging, use the no logging coredump server server username username
password password
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
You must use this command to enable core dump logging before a software exception occurs. If the
FTP server is unreachable, FTOS aborts the application core dump.
server
Enter the hostname or IP address of the FTP server where FTOS sends
application core dumps.
username
Enter the username to access the FTP server.
type
Enter the password type. Enter 0 to specify that an unencrypted password will
follow, or 7 to specify that a Type 7 encrypted password will follow.
password
Enter the password to access the FTP server.
Version 8.3.5.0 Introduced on S55
Version 7.7.1.0 Introduced on S-Series