Command Line Reference Guide

1044 | Time and Network Time Protocol (NTP)
www.dell.com | support.dell.com
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Related
Commands
clock timezone
c e s
Configure a timezone for the switch.
Syntax
clock timezone timezone-name offset
To delete a timezone configuration, enter no clock timezone.
Parameters
Default
Not configured.
end-week
Enter the one of the following as the week that daylight savings ends:
•
week-number: enter a number from 1-4 as the number of the week to end daylight
savings time.
•
first: enter the keyword first to end daylight savings time in the first week of the
month.
•
last: enter the keyword last to end daylight savings time in the last week of the month.
end-day
Enter the weekday name that you want daylight saving time to end. Enter the weekdays
using the three letter abbreviations, for example Sun, Sat, Mon etc.
Range: Sun to Sat
end-month
Enter the name of one of the 12 months in English.
end-time
Enter the time in hours:minutes:seconds. For the hour variable, use the 24-hour format,
example, 17:15:00 is 5:15 pm.
offset
(OPTIONAL) Enter the number of minutes to add during the summer-time period.
Range: 1 to 1440.
Default: 60 minutes.
Version 8.3.5.0 Introduced on S55
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
Version 7.4.1.0
Updated the
start-day and end-day options to allow for using the three-letter
abbreviation of the weekday name.
pre-Version 6.1.1.0 Introduced for E-Series
calendar set Set the hardware clock.
clock summer-time date Set a date (and time zone) on which to convert the switch to daylight savings
time on a one-time basis.
show clock Display the current clock settings.
timezone-name
Enter the name of the timezone. You cannot use spaces.
offset
Enter one of the following:
• a number from 1 to 23 as the number of hours in addition to UTC for the
timezone.
• a minus sign (-) followed by a number from 1 to 23 as the number of hours