Command Line Reference Guide

1026 | S-Series Stacking Commands
www.dell.com | support.dell.com
Command Modes
CONFIGURATION
Command
History
Usage
Information
The S60 and the S60 do not support stacking with other platforms. You can only stack the S60 with
other S60 systems and the S55 with other S55 systems.
Related
Commands
stack-unit renumber
s
Change the stack member ID of any stack member or a stand-alone S-Series.
Syntax
stack-unit stack-unit renumber stack-unit
Parameters
Defaults
none
Command Modes
EXEC Privilege
Command
History
Usage
Information
You can renumber any switch, including the management unit or a stand-alone unit.
You cannot renumber a unit to a number of an active member in the stack.
When executing this command on the master, the stack reloads. When the members are renumbered,
only that specific unit will reset and come up with the new unit number.
Example
Figure 41-11. stack-unit renumber Command Example
Related
Commands
Version 8.3.5.1 Introduced on S55
Version 7.7.1.0 Introduced on S-Series
reload Reboot FTOS.
show system (S-Series) Display the current status of all stack members or a specific member.
stack-unit
Enter the stack member unit identifier of the stack member to reset.
S55 range: 0 - 11
The first instance of this value is the stack member unit identifier, from 0 to 11, of
the switch that you want add to the stack.
The second instance of this value is the desired new unit identifier number.
Version 8.3.5.1 Introduced on S55
Version 7.7.1.0 Introduced on S-Series
Force10#stack-unit 0 renumber 2
Renumbering master unit will reload the stack. Proceed to renumber [confirm yes/
no]:
reload Reboot FTOS.
reset stack-unit Reset the designated S-Series stack member.
show system (S-Series) Display the current status of all stack members or a specific member.