Command Line Reference Guide

S-Series Stacking Commands | 1021
Figure 41-4. show redundancy (S55)
Related
Commands
show system stack-ports
s
Display information about the stacking ports on all switches in the S-Series stack.
Syntax
show system stack-ports [status | topology]
Parameters
Defaults
No default behavior
Force110#show redundancy
-- Stack-unit Status --
------------------------------------------------
Mgmt ID: 0
Stack-unit ID: 0
Stack-unit Redundancy Role: Primary
Stack-unit State: Active
Stack-unit SW Version: E8-3-5-34
Link to Peer: Up
-- PEER Stack-unit Status --
------------------------------------------------
Stack-unit State: Standby
Peer stack-unit ID: 1
Stack-unit SW Version: E8-3-5-34
-- Stack-unit Redundancy Configuration --
------------------------------------------------
Primary Stack-unit: mgmt-id 0
Auto Data Sync: Full
Failover Type: Hot Failover
Auto reboot Stack-unit: Enabled
Auto failover limit: 3 times in 60 minutes
-- Stack-unit Failover Record --
------------------------------------------------
Failover Count: 0
Last failover timestamp: None
Last failover Reason: None
Last failover type: None
-- Last Data Block Sync Record: --
------------------------------------------------
Stack Unit Config: succeeded Jan 16 2011 04:29:22
Start-up Config: succeeded Jan 16 2011 04:29:22
Runtime Event Log: succeeded Jan 16 2011 04:20:39
Running Config: succeeded Jan 16 2011 04:20:43
ACL Mgr: succeeded Jan 16 2011 04:20:39
LACP: no block sync done
STP: no block sync done
SPAN: no block sync done
Force10#
redundancy disable-auto-reboot Prevent the system from auto-rebooting if it fails.
status (OPTIONAL) Enter the keyword status to display the command output without the
Connection field.
topology (OPTIONAL) Enter the keyword topology to limit the table to just the Interface and
Connection fields.