Command Line Reference Guide

S-Series Stacking Commands | 1015
41
S-Series Stacking Commands
Overview
All commands in this chapter are specific to the S-Series platform, as indicated by the s character
that appears below each command heading. The commands are always available and operational,
whether or not the S-Series has a stacking module inserted. You can use the commands to
pre-configure a switch, so that the configuration settings are invoked when the switch is attached to
other S-Series units.
For details on using the S-Series stacking feature, see the chapter “Stacking S-Series Switches” in the
FTOS Configuration Guide.
The S55 supports stacking with FTOS version 8.3.5.1 and later.
Commands
The commands in this chapter are used for managing the stacking of S-Series systems:
• power-cycle
• redundancy disable-auto-reboot
• redundancy force-failover stack-unit
• reset stack-unit
• show redundancy
• show system stack-ports
• stack-unit priority
• stack-unit provision
• stack-unit renumber
• upgrade system stack-unit (S-Series stack member)
power-cycle
Power-cycle the unit.
Syntax
power-cycle stack-unit [stack-unit | all]