Command Line Reference Guide

1000 | SNMP and Syslog
www.dell.com | support.dell.com
Parameters
Defaults
Disabled. If enabled without level or number-of-buffers options specified, level = 2 and
number-of-buffers = 20 are the defaults.
Command Modes
LINE
Command
History
Usage
Information
When logging synchronous is enabled, unsolicited messages appear between software prompts and
outputs. Only the messages with a severity at or below the set level are sent to the console.
If the message queue limit is reached on a terminal line and messages are discarded, a system message
appears on that terminal line. Messages may continue to appear on other terminal lines.
Related
Commands
logging trap
c e s
Specify which messages are logged to the Syslog server based the message severity.
Syntax
logging trap [level]
To return to the default values, enter default logging trap. To disable logging, enter no logging
trap
.
Parameters
Defaults
6 or informational
Command Modes
CONFIGURATION
Command
History
all Enter the keyword all to ensure that all levels are printed asynchronously.
level level Enter the keyword level followed by a number as the severity level. A
high number indicates a low severity level and visa versa.
Range: 0 to 7.
Default: 2
all Enter the keyword all to turn off all
limit number-of-buffers Enter the keyword limit followed by the number of buffers to be queued
for the terminal after which new messages are dropped
Range: 20 to 300
Default: 20
Version 8.3.5.0 Introduced on S55
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
logging on Enables logging.
level
Indicate a value from 0 to 7 or enter one of the following parameters: emergencies, alerts,
critical, errors, warnings, notifications, informational, or debugging.
The default is 6.
Version 8.3.5.0 Introduced on S55
Version 7.6.1.0 Support added for S-Series