Command Line Reference Guide

100 | Control and Monitoring
www.dell.com | support.dell.com
Examples
Figure 4-14. Command Example: show environment
Figure 4-15. Command Example: show environment fan
show environment (S-Series)
s
View S-Series system component status (for example, temperature, voltage).
Syntax
show environment [all | fan | stack-unit unit-id | pem | thermal-sensor]
Parameters
Force10#show environment
-- Fan Status --
Status Temp Fan1 Fan2 Fan3 Serial Num Version
---------------------------------------------------------------------------
up 32C 6000 RPM 6000 RPM 7500 RPM FX000040889 3.2
-- Power Supplies --
Bay Status
---------------------------------------------------------------------------
0 absent
1 up
2 up
3 up
-- Line Card Environment Status --
Slot Status Temp Voltage
---------------------------------------------------------------------------
0 not present
1 online 66C ok
2 not present
3 online 59C ok
4 online 64C ok
5 not present
6 online 59C ok
-- RPM Environment Status --
Slot Status Temp Voltage
---------------------------------------------------------------------------
0 active 36C ok
1 not present
-- SFM Environment Status --
Force10#
Force10#show environment fan
-- Fan Status --
Status Temp Fan1 Fan2 Fan3 Serial Num Version
---------------------------------------------------------------------
-
up 32C 6000 RPM 6000 RPM 6000 RPM FX000040889 3.2
all Enter the keyword all to view all components.
fan Enter the keyword fan to view information on the fans. The output of this
command is chassis dependent.
stack-unit unit-id Enter the keyword stack-unit followed by the unit-id to display information on
a specific stack member.
Unit ID range:
S55: 0-11
all other S-Series: 0-7