Reference Guide

File Management | 45
When restoring a single unit in a stack, that unit placed in stand-alone mode. No other units in the stack
are affected.
When restoring units in stand-alone mode, the units remain in stand-aline mode after the restoration.
After the restore is complete, the units power cycle immediately.
Example
Figure 3-5. restore factory-defaults (all units in a stack) Command Example
Figure 3-6. restore factory-defaults (single unit in a stack) Command Example
Caution: There is no undo for this command.
FTOS#restore factory-defaults stack-unit all clear-all
***********************************************************************
* Warning - Restoring factory defaults will delete the existing *
* startup-config and all persistent settings (stacking, fanout, etc.)*
* All the units in the stack will be split into standalone units. *
* After restoration the unit(s) will be powercycled immediately. *
* Proceed with caution ! *
***********************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
0 Success Success
1 Success Success
2 Success Success
3 Not present
4 Not present
5 Not present
Power-cycling the unit(s).
FTOS#
FTOS#restore factory-defaults stack-unit 0 clear-all
***********************************************************************
* Warning - Restoring factory defaults will delete the existing *
* startup-config and all persistent settings (stacking, fanout, etc.)*
* After restoration the unit(s) will be powercycled immediately. *
* Proceed with caution ! *
***********************************************************************
Proceed with factory settings? Confirm [yes/no]:yes
-- Restore status --
Unit Nvram Config
------------------------
0 Success Success
Power-cycling the unit(s).
FTOS#