Reference Guide

324 | Border Gateway Protocol IPv4(BGPv4)
www.dell.com | support.dell.com
Command
History
neighbor soft-reconfiguration inbound
c e s
Enable soft-reconfiguration for BGP.
Syntax
neighbor {ip-address | peer-group-name} soft-reconfiguration inbound
To disable, use the no neighbor {ip-address | peer-group-name} soft-reconfiguration inbound
command.
Parameters
Defaults
Disabled
Command Modes
ROUTER BGP
Usage
Information
This command enables soft-reconfiguration for the BGP neighbor specified. BGP will store all the
updates received by the neighbor but will not reset the peer-session.
Related
Commands
Command
History
neighbor subnet
c e s
Enable passive peering so that the members of the peer group are dynamic
Syntax
neighbor peer-group-name subnet subnet-number mask
To remove passive peering, use the no neighbor peer-group-name subnet subnet-number mask
command.
Version 8.3.5.0 Introduced on the S55.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
ip-address
Enter the IP address of the neighbor in dotted decimal format.
peer-group-name
Enter the name of the peer group to disable or enable all routers within the
peer group.
Caution: Inbound update storage is a memory-intensive operation. The entire BGP update
database from the neighbor is stored in memory regardless of the inbound policy results
applied on the neighbor.
Note: This command is supported in BGP Router Configuration mode for IPv4 Unicast
address only.
show ip bgp neighbors Display routes received by a neighbor
Version 8.3.5.0 Introduced on the S55.
Version 7.8.1.0 Introduced support on S-Series
Version 7.7.1.0 Introduced support on C-Series
Version 7.4.1.0 Introduced