Reference Guide

152 | Control and Monitoring
www.dell.com | support.dell.com
Command Modes
EXEC
EXEC Privilege
Command
History
telnet-peer-rpm
c e
Open a Telnet connection to the peer RPM.
Syntax
telnet-peer-rpm
Defaults
Not configured.
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Information
Opening a telnet connection from the Standby RPM to an Active RPM follows the authentication
procedure configured in the chassis. However, opening a telnet connection from the Active RPM into
the Standby RPM requires local authentication.
Configuring an ACL on a VTY line will block a Telnet session using the telnet-peer-rpm command
in the standby to active RPM direction only. Such an ACL will not block an internal Telnet session in
the active RPM to standby RPM direction.
telnet-peer-stack-unit
Open a Telnet connection to the peer stack unit.
Syntax
telnet-peer-stack-unit
Defaults
Not configured.
Command Modes
EXEC
EXEC Privilege
Version 8.3.5.0 Introduced on the S55.
Version 8.2.1.0 Introduced on E-Series ExaScale (IPv6)
Increased number of VLANs on ExaScale to 4094 (was 2094)
Version 8.1.1.0 Introduced on E-Series ExaScale (IPv4)
Version 7.9.1.0 Introduced VRF.
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series and added support for IPv6 address on E-Series only
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.5.1.0 Introduced on C-Series
Version 6.2.1.1 Introduced on E-Series