Reference Guide

718 | Stacking S-Series Switches
www.dell.com | support.dell.com
Remove a Unit from an S-Series Stack
The running-configuration and startup-configuration are synchronized on all stack units. A stack member
that is disconnected from the stack maintain this configuration.
To remove a stack member from the stack, disconnect the stacking cables from the unit. You may do this at
any time, whether the unit is powered or not powered, online or offline. Note that if you remove a unit in
the middle of the stack in a cascade topology, the stack will be split into multiple parts, and each will form
a new stack according to the stacking algorithm described throughout this chapter.
Figure 39-15. Removing a Stack Member—Before (S50 type)
----------------------------STANDALONE BEFORE DISCONNECTION----------------------------------
Standalone(stack-member-2)#?
reset-self Reset this unit alone
show Show running system information
Standalone(stack-member-2)#show ?
version Software version
---------------------------------STACK BEFORE DISCONNECTION----------------------------------
Stack#show system brief
Stack MAC : 00:01:e8:d5:f9:6f
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp Version Ports
---------------------------------------------------------------------------
0 Standby online S50V S50V 7.8.1.0 52
1 Management online S50N S50N 7.8.1.0 52
2 Member online S50V S50V 7.8.1.0 52
3 Member not present
4 Member not present
5 Member not present
6 Member not present
7 Member not present