Reference Guide

ManualsBrandsDell ManualsserversDell Force10 S55T

711

712

713

714

715

716

717

718

719

720

Stacking S-Series Switches | 711

Figure 39-16. Removing a Stack Member—After (S50 type)

Replace a Stack Member

To replace a non-functional stack member:

Step Task Command Syntax Command Mode

1 Verify that each unit has the same FTOS version prior to

stacking them together.

show version

EXEC Privilege

2 Insert the replacement unit only without connecting the stacking cables before powering the unit.

3 Assign the stack-unit number of the unit that was

replaced to the replacement unit.

stack-unit <stack-unit>

renumber <stack-unit>

EXEC Privilege

----------------------------STANDALONE AFTER DISCONNECTION----------------------------------

Standalone(stack-member-2)#

Going for reboot. Reason is Stack split

[bootup messages omitted]

Stack#show system brief

Stack MAC : 00:01:e8:d5:ef:81

-- Stack Info --

Unit UnitType Status ReqTyp CurTyp Version Ports

---------------------------------------------------------------------------

0 Member not present S50V

1 Member not present S50N

2 Management online S50V S50V 7.8.1.0 52

3 Member not present

4 Member not present

5 Member not present

6 Member not present

7 Member not present

[output omitted]

---------------------------------STACK AFTER DISCONNECTION----------------------------------

Stack#3w1d15h: %STKUNIT1-M:CP %CHMGR-2-STACKUNIT_DOWN: Stack unit 2 down - card removed

3w1d15h: %STKUNIT1-M:CP %IFMGR-1-DEL_PORT: Removed port: Gi 2/1-48

3w1d15h: %STKUNIT0-S:CP %IFMGR-1-DEL_PORT: Removed port: Gi 2/1-48

Stack#show system brief

Stack MAC : 00:01:e8:d5:f9:6f