Reference Guide

Security | 617
SCP is a remote file copy program that works with SSH and is supported by FTOS.
To use the SSH client, use the following command in the EXEC Privilege mode:
To enable the SSH server for version 1 and 2, use the following command in the CONFIGURATION
mode:
To enable the SSH server for version 1 or 2 only, use the following command:
To view the SSH configuration, use the following command in EXEC Privilege mode:
Figure 34-6 on page 618 shows the use of the command
ip ssh server version 2 to enable SSH version 2,
and the
show ip ssh command to confirm the setting.
Note: The Windows-based WinSCP client software is not supported for secure copying between a PC
and an FTOS-based system. Unix-based SCP client software is supported.
Command Syntax Command Mode Purpose
ssh {hostname} [-l username | -p
port-number | -v {1 | 2}
EXEC Privilege Open an SSH connection specifying the hostname,
username, port number, and version of the SSH client.
hostname is the IP address or hostname of the remote
device.
• Enter an IPv4 address in dotted decimal format
(A.B.C.D).
Command Syntax Command Mode Purpose
ip ssh server {enable | port port-number} CONFIGURATION
Configure the Dell Networking system as
an SCP/SSH server.
Command Syntax Command Mode Purpose
ip ssh server version {1|2} CONFIGURATION
Configure the Dell Networking system as an SSH server
that uses only version 1 or 2.
Command Syntax Command Mode Purpose
show ip ssh EXEC Privilege Display SSH connection information.