Reference Guide

58 | Management
www.dell.com | support.dell.com
Configure FTP client parameters
To configure FTP client parameters, use the following commands in the CONFIGURATION mode:
To view FTP configuration, use the
show running-config ftp command (Figure 41) in the EXEC privilege
mode.
Terminal Lines
You can access the system remotely and restrict access to the system by creating user profiles. The terminal
lines on the system provide different means of accessing the system. The console line (console) connects
you through the Console port in the RPMs. The virtual terminal lines (VTY) connect you through Telnet to
the system. The auxiliary line (aux) connects secondary devices such as modems.
Deny and Permit Access to a Terminal Line
Dell Networking recommends applying only standard ACLs to deny and permit access to VTY lines.
• Layer 3 ACL deny all traffic that is not explicitly permitted, but in the case of VTY lines, an ACL with
no rules does not deny any traffic.
• You cannot use
show ip accounting access-list to display the contents of an ACL that is applied only to
a VTY line.
Command Syntax Command Mode Purpose
ip ftp source-interface interface CONFIGURATION Enter the following keywords and slot/port or number
information:
• For a Gigabit Ethernet interface, enter the keyword
GigabitEthernet followed by the slot/port
information.
• For a loopback interface, enter the keyword
loopback
followed by a number between 0 and 16383.
• For a port channel interface, enter the keyword
port-channel followed by a number from 1 to 255 for
TeraScale and ExaScale.
• For a SONET interface, enter the keyword
sonet
followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet followed by the slot/port
information.
• For a VLAN interface, enter the keyword
vlan
followed by a number from 1 to 4094.
E-Series ExaScale platforms support 4094 VLANs
with FTOS version 8.2.1.0 and later. Earlier
ExaScale supports 2094 VLANS.
ip ftp password password
CONFIGURATION Configure a password.
ip ftp username name CONFIGURATION Enter username to use on FTP client.