Reference Guide

188 | Border Gateway Protocol IPv4 (BGPv4)
www.dell.com | support.dell.com
Use the keyword no followed by the debug command To disable a specific debug command. For example,
to disable debugging of BGP updates, enter
no debug ip bgp updates command.
Use
no debug ip bgp to disable all BGP debugging.
Use
undebug all to disable all debugging.
Storing Last and Bad PDUs
FTOS stores the last notification sent/received, and the last bad PDU received on per peer basis. The last
bad PDU is the one that causes a notification to be issued. These PDUs are shown in the output of the
command
show ip bgp neighbor, as shown in Figure 8-34.