Command Line Reference Guide

Interfaces | 637
LineSpeed 10 Mbit, Mode half duplex
ARP type: ARPA, ARP Timeout 04:00:00
Last clearing of "show interface" counters 04:01:08
Queueing strategy: fifo
Input 943 packets, 78347 bytes, 190 multicast
Received 0 errors, 0 discarded
Output 459 packets, 102388 bytes, 15 multicast
Output 0 errors, 0 invalid protocol
Time since last interface status change: 00:03:09
Usage
Information
On the C-Series and S-Series, the interface counter “over 1023-byte pkts” does not increment
for packets in the range 9216 > x < 1023.
The Management port is enabled by default (no shutdown). If necessary, use the
ip address
command to assign an IP address to the Management port. If two RPMs are installed in your
system, use the
show redundancy command to display which RPM is the Primary RPM.
Related
Commands
show interfaces configured
c e s
Display any interface with a non-default configuration.
Syntax
show interfaces configured
Command Modes
EXEC
EXEC Privilege
Command
History
show interfaces configured Display any interface with a non-default configuration.
show interfaces linecard Display information on all interfaces on a specific line card.
show interfaces phy
show interfaces rate Display information of either rate limiting or rate policing on the
interface.
show interfaces switchport Display Layer 2 information about the interfaces.
show inventory (C-Series
and E-Series)
Display the chassis type, components (including media), FTOS
version including hardware identification numbers and configured
protocols.
show inventory (S-Series) Display the S-Series switch type, components (including media),
FTOS version including hardware identification numbers and
configured protocols.
show ip interface Display Layer 3 information about the interfaces.
show linecard Display the line card(s) status.
show range Display all interfaces configured using the interface range
command.
Version 8.3.19.0 Introduced on S4820T
Version 8.3.7.0 Introduced on S4810