Command Line Reference Guide

1438 | Simple Network Management Protocol and Syslog
www.dell.com | support.dell.com
Syntax
logging synchronous
[level level | all] [limit number-of-buffers]
To disable message synchronization, use the
no logging synchronous [level level | all]
[
limit number-of-buffers] command.
Parameters
Defaults
Disabled. If enabled without level or number-of-buffers options specified, level = 2 and
number-of-buffers = 20 are the defaults.
Command Modes
LINE
Command
History
Usage
Information
When logging synchronous is enabled, unsolicited messages appear between
software prompts and outputs. Only the messages with a severity at or below the set
level are sent to the console.
If the message queue limit is reached on a terminal line and messages are discarded, a
system message appears on that terminal line. Messages may continue to appear on
other terminal lines.
Related
Commands
logging trap
c e s z
Specify which messages are logged to the Syslog server based on the message
severity.
Syntax
logging trap
[level]
all
Enter the keyword all to ensure that all levels are printed
asynchronously.
level level Enter the keyword level followed by a number as the severity level.
A high number indicates a low severity level and visa versa.
Range: 0 to 7.
Default: 2
all Enter the keyword all to turn off all
limit number-of-buffers Enter the keyword limit followed by the number of buffers to be
queued for the terminal after which new messages are dropped
Range: 20 to 300
Default: 20
Version 8.3.19.0 Introduced on S4820T
Version 8.3.11.1 Introduced on Z9000
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Support added for S-Series
Version 7.5.1.0 Support added for C-Series
E-Series legacy command
logging on Enables logging.