Command Reference Guide

978 | Multicast Source Discovery Protocol (MSDP)
www.dell.com | support.dell.com
Parameters
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
Usage
Information
If a list is not specified, all SA messages received from the default peer are accepted. You can
enter multiple default peer commands.
ip msdp log-adjacency-changes
e
Enable logging of MSDP adjacency changes.
Syntax
ip msdp log-adjacency-changes
To disable logging, use the no ip msdp log-adjacency-changes command.
Defaults
Not configured
Command Modes
CONFIGURATION
Command
History
ip msdp mesh-group
e
Configure a peer to be a member of a mesh group.
Syntax
ip msdp mesh-group
{name} {peer address}
To remove the peer from a mesh group, use the no ip msdp mesh-group {name} {peer address}
command.
Parameters
Defaults
Not configured
peer address
Enter the peer address in a dotted decimal format (A.B.C.D.)
list name Enter this keyword and specify a standard access list that contains the RP
address that should be treated as the default peer. If no access list is
specified, then all SAs from the peer are accepted.
Version 8.3.7.0 Introduced on S4810
Version 7.8.1.0 Added the
list option, and removed the prefix-list option.
Version 6.2.1.1 Introduced
Version 8.3.7.0 Introduced on S4810
Version 6.2.1.1 Introduced
name
Enter a string of up to 16 characters long for as the mesh group name.
peer address
Enter the peer address in a dotted decimal format (A.B.C.D.)