Command Reference Guide

Link Layer Discovery Protocol (LLDP) | 959
Parameters
Defaults
No default values or behavior
Command Modes
EXEC Privilege
Command
History
debug lldp interface
c e s
Enable LLDP debugging to display timer events, neighbor additions or deletions, and other
information about incoming and outgoing packets.
Syntax
debug lldp interface
{interface | all}{events | packet {brief | detail} {tx | rx | both}}
To disable debugging, use the
no debug lldp interface {interface | all}{events} {packet {brief |
detail} {tx | rx | both}} command.
Parameters
interface
Enter the following keywords and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword
FastEthernet followed by
the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword
gigabitEthernet
followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed
by the slot/port information.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on S4810
Version 7.7.1.0 Introduced on S-Series
Version 7.6.1.0 Introduced on C-Series
Version 7.4.1.0 Introduced on E-Series
interface
Enter the following keywords and slot/port or number information:
• For a Fast Ethernet interface, enter the keyword FastEthernet followed
by the slot/port information.
• For a 1-Gigabit Ethernet interface, enter the keyword gigabitEthernet
followed by the slot/port information.
• For a 10-Gigabit Ethernet interface, enter the keyword
tenGigabitEthernet followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE
followed by the slot/port information.
Note: The FastEthernet option is not supported on S-Series.
all
(OPTIONAL) Enter the keyword all to display information on all interfaces.
events
(OPTIONAL) Enter the keyword events to display major events such as
timer events.
packet
(OPTIONAL) Enter the keyword packet to display information regarding
packets coming in or going out.
brief
(OPTIONAL) Enter the keyword brief to display brief packet information.