Command Reference Guide

950 | Layer 2
www.dell.com | support.dell.com
Command
History
Usage
Information
If you enter only the fefd-global syntax, the mode is normal and the default interval is 15
seconds.
If you disable FEFD globally (no fefd-global), the system does not remove the FEFD
interface configuration.
fefd-global interval
e
Configure an interval between FEFD control packets.
Syntax
fefd-global interval seconds
To return to the default value, enter no fefd-global interval.
Parameters
Defaults
15 seconds
Command Modes
CONFIGURATION
Related
Commands
Command
History
fefd interval
e
Set an interval between control packets.
Syntax
fefd interval seconds
To return to the default value, enter no fefd interval.
Parameters
Defaults
15 seconds
Version 8.3.12.0 Introduced on S4810.
Legacy E-Series command
seconds
Enter a number as the time between FEFD control packets.
Range: 3 to 300 seconds
Default: 15 seconds
fefd Enable Far-End Failure Detection.
fefd-global Enable FEFD globally on the system.
Version 8.3.12.0 Introduced on S4810.
Legacy E-Series command
seconds
Enter a number as the time between FEFD control packets.
Range: 3 to 300 seconds
Default: 15 seconds