Command Reference Guide

Control and Monitoring | 95
Command Modes
EXEC Privilege
Command
History
Usage
Information
The command reset without any options is a soft reset, which means FTOS boots the line card
from its runtime image. The
hard option reloads the FTOS image on the line card. Use the
power-cycle after upgrading an FPGA.
When a soft reset is issued on a line card (
reset linecard number), FTOS boots the line card
from its runtime image. Only when you enter
reset linecard number hard is the software
image reloaded on the line card.
Related
Commands
rpm <slot> location-led
e
x
Toggle the location LED on/off on the E-Series ExaScale RPM (LC-EH-RPM).
Syntax
rpm slot number location-led [on | off]
Parameters
Defaults
OFF
Command Modes
EXEC
Command
History
Usage
Information
The LED setting is not saved through power cycles.
send
c e s
Send messages to one or all terminal line users.
Syntax
send [*] | [line ] | [aux] | [console] | [vty]
Parameters
Version 7.5.1.0 Introduced on C-Series
E-Series original Command
reload Reboots the system.
restore fpga-image Copy the backup C-Series FPGA image to the primary FPGA image.
rpm slot number Enter the slot number
E1200i: 0-13
E600i: 0-6
on |off
Toggles the LED on the RPM on or off.
Version 8.2.1.0 Introduced on the E-Series ExaScale
* Enter the asterisk character * to send a message to all tty lines.
line Send a message to a specific line.
Range: 0 to 11