Command Reference Guide

944 | Layer 2
www.dell.com | support.dell.com
tagged
c e s
Add a Layer 2 interface to a VLAN as a tagged interface.
Syntax
tagged interface
To remove a tagged interface from a VLAN, use no tagged interface command.
Parameters
Defaults
All interfaces in Layer 2 mode are untagged.
Command Modes
INTERFACE VLAN
Command
History
Usage
Information
When you use the no tagged command, the interface is automatically placed in the Default
VLAN as an untagged interface unless the interface is a member of another VLAN. If the
interface belongs to several VLANs, you must remove it from all VLANs to change it to an
untagged interface.
Tagged interfaces can belong to multiple VLANs, while untagged interfaces can only belong
to one VLAN at a time.
Related
Commands
interface
Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword
GigabitEthernet
followed by the slot/port information.
• For a Port Channel interface, enter the keyword
port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by
the slot/port information.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.1 Introduced on E-Series
interface vlan Configure a VLAN.
untagged Specify which interfaces in a VLAN are untagged.