Command Reference Guide

Layer 2 | 939
100000 packets, 10000000 bytes
Output Statistics:
200000 packets, 20800000 bytes
Time since last interface status change: 01:36:01
FTOS#
Usage
Information
FTOS supports a command to enable viewing of the VLAN input/output counters. This
command also applies to SNMP requests. If the command is not enabled, IFM returns zero
values for VLAN output counters.
SNMP counters differ from show interface counters as SNMP counters must maintain history.
At any point, the value of SNMP counters reflect the amount of traffic being carried on the
VLAN.
VLAN output counters may show higher than expected values because source-suppression
drops are counted.
During an RPM failover event, all SNMP counters remain intact. The counters will sync over
to the secondary RPM.