Command Reference Guide

936 | Layer 2
www.dell.com | support.dell.com
Example
(C-Series &
S-Series)
C-Series/S-Series output:
FTOS#show mac learning-limit
Interface Learning Dynamic Static Unknown SA
Slot/port Limit MAC count MAC count Drops
Gi 1/0 10 0 0 0
Gi 1/1 5 0 0 0
FTOS#show mac learning-limit interface gig 1/0
Interface Learning Dynamic Static Unknown SA
Slot/port Limit MAC count MAC count Drops
Gi 1/0 10 0 0 0
Virtual LAN (VLAN) Commands
The following commands configure and monitor Virtual LANs (VLANs). VLANs are a
virtual interface and use many of the same commands as physical interfaces.
You can configure an IP address and Layer 3 protocols on a VLAN called Inter-VLAN
routing. FTP, TFTP, ACLs and SNMP are not supported on a VLAN.
Occasionally, while sending broadcast traffic over multiple Layer 3 VLANs, the VRRP state
of a VLAN interface may continually switch between Master and Backup.
• description
• default vlan-id
• default-vlan disable
• enable vlan-counters
• name
• show config
• show vlan
• tagged
• track ip
• untagged
Refer also to VLAN Stacking and VLAN-related commands, such as portmode hybrid, in the
Interfaces chapter.
description
c e s
Add a description about the selected VLAN.
Syntax
description description
To remove the description from the VLAN, use the no description command.
Parameters
description
Enter a text string description to identify the VLAN (80 characters maximum).