Command Reference Guide

Layer 2 | 919
Command
History
Related
Commands
mac-address-table station-move threshold
c e
Change the frequency with which the MAC address station-move trap is sent after a MAC
address changes in a VLAN. A trap is sent if a station move is detected above a threshold
number of times in a given interval.
Syntax
[no] mac-address-table station-move threshold number interval count
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Usage
Information
For information on the specific trap sent and the corresponding Syslog refer to Chapter 60,
SNMP Traps.
mac-address-table station-move time-interval
e
Reduce the amount of time FTOS takes to detect aged entries and station moves.
Syntax
[no] mac-address-table station-move time-interval number
Parameters
Defaults
5000ms
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
show mac-address-table Displays the MAC address table.
threshold number Enter the keyword threshold followed by the number of times MAC
addresses in VLANs can change before an SNMP trap is sent.
Range: 1 to 10
interval seconds Enter the keyword interval followed by the number of seconds.
Range: 5 to 60
Version 8.3.7.0 Introduced on S4810
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
time-interval number Select the interval of the successive scans of the MAC address table
that are used to detect a aged entries and station moves.
Range: 500 to 5000ms