Command Reference Guide

Intermediate System to Intermediate System (IS-IS) | 891
Defaults
Disabled
Command Mode
CONFIGURATION-ROUTER-ISIS-ADDRESS-FAMILY-IPV6
Command
History
net
e
Use this mandatory command to configure an IS-IS network entity title (NET) for a routing process. If
a NET is not configured, the IS-IS process will not start.
Syntax
net network-entity-title
To remove a net, enter no net network-entity-title.
Parameters
Defaults
Not configured.
Command Modes
ROUTER ISIS
Command
History
passive-interface
e
Suppress routing updates on an interface. This command stops the router from sending updates on that
interface.
Syntax
passive-interface interface
To delete a passive interface configuration, enter the no passive-interface interface command.
Version 8.3.12.0 Introduced on S4810
Version 7.8.1.0 Introduced
network-entity-title
Specify the area address and system ID for an IS-IS routing process. The first 1
to 13 bytes identify the area address. The next 6 bytes identify the system ID.
The last 1 byte is the selector byte, always identified as zero zero (00). This
argument can be applied to an address or a name.
Version 8.3.12.0 Introduced on S4810