Command Reference Guide

856 | iSCSI Optimization
www.dell.com | support.dell.com
iscsi profile-compellant
Configure the auto-detection of Compellent arrays on a port.
Syntax
iscsi profile-compellent
Defaults
Compellent disk arrays are not detected.
Command Modes
INTERFACE
Command
History
iscsi target port
Configure the iSCSI target ports and optionally, the IP addresses on which iSCSI communication will
be monitored.
Syntax
iscsi target port [tcp-port-2...tcp-port-16]ip-address [ip-address]
To remove the configured iSCSI target ports or IP addresses, use the no iscsi target port command.
Parameters
Defaults
860, 3260.
Command Modes
CONFIGURATION
Command
History
Usage
Information
You can configure up to 16 target TCP ports on the switch in one command or multiple commands.
When you use the no iscsi target port command and the TCP port to be deleted is one bound to a
specific IP address, the IP address value must be included in the command.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module
tcp-port-2...tcp-
port-16
Enter the tcp-port number of the iSCSI target ports.
The
tcp-port-n is the TCP port number or a list of TCP port numbers on which the
iSCSI target listens to requests. Separate port numbers with a comma.
Default: 860, 3260.
ip-address
(Optional) Enter the ip-address that the iSCSI will monitor.
The ip-address specifies the IP address of the iSCSI target.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module