Command Reference Guide

iSCSI Optimization | 855
Command
History
Usage
Information
By default, iSCSI flows are assigned to dot1p priority 4. Dell Force10 recommends changing
the dot1p priority-queue setting to 0 (zero).
iscsi enable
Globally enable iSCSI optimization.
Syntax
iscsi enable
To disable iSCSI optimization, use the no iscsi enable command.
Parameters
Defaults
Enabled.
Command Modes
CONFIGURATION
Command
History
Usage
Information
• LLDP must be enabled before using this command.
• LLDP cannot be disabled if iSCSI is enabled.
iscsi priority-bits
Configure the priority bitmap to be advertised in iSCSI application TLVs.
Syntax
iscsi priority-bits
To remove the configured priority bitmap, use the no iscsi priority-bits command.
Defaults
4 (0x10 in the bitmap)
Command Modes
PROTOCOL LLDP (only on global, not on interface)
Command
History
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module
enable Enter the keyword enable to enable the iSCSI optimization feature.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.16.0 Introduced on MXL 10/40GbE Switch IO Module