Command Reference Guide

786 | IPv6 Border Gateway Protocol (IPv6 BGP)
www.dell.com | support.dell.com
Command
History
debug ip bgp keepalives
c e
Allows you to view information about BGP keepalive messages.
Syntax
debug ip bgp [ipv6-address | peer-group peer-group-name] keepalives [in | out]
To disable debugging, use the
no debug ip bgp [ip-address | peer-group peer-group-name]
keepalives [in | out] command.
Parameters
Command Modes
EXEC Privilege
Command
History
Usage
Information
Enter the no debug ip bgp command to remove all configured debug commands for BGP.
debug ip bgp notifications
c e
Allows you to view information about BGP notifications received from neighbors.
Syntax
debug ip bgp [ipv6-address | peer-group peer-group-name] notifications [in | out]
To disable debugging, use the
no debug ip bgp [ip-address | peer-group peer-group-name]
notifications [in | out] command.
Version 8.4.1.0 Added support for IPv4 multicast and IPv6 unicast routes
Version 7.8.1.0 Introduced support on S4810
Version 7.7.1.0 Introduced support on C-Series
Version 7.2.1.0 Introduced on the E-Series TeraScale
ipv6-address
(OPTIONAL) Enter the IPv6 address in the x:x:x:x::x format
followed by the prefix length in the /x format.
Range: /0 to /128
The :: notation specifies successive hexadecimal fields of zeros.
peer-group peer-group-name
(OPTIONAL) Enter the keyword peer-group followed by the
name of the peer group.
in (OPTIONAL) Enter the keyword in to view only inbound
keepalive messages.
out
(OPTIONAL) Enter the keyword out to view only outbound
keepalive messages.
Version 8.4.2.1 Introduced on C-Series and S4810
Version 8.2.1.0 Introduced on E-Series ExaScale
Version 7.4.1.0 Introduced on E-Series TeraScale