Command Reference Guide

IPv6 Basics | 741
clear ipv6 mld_host
Clear the IPv6 MLD host counters and reset the elapsed time.
Syntax
clear ipv6 mld_host
Command Modes
EXEC
Command
History
ipv6 address autoconfig
Configure IPv6 address auto-configuration for the management interface.
Syntax
ipv6 address autoconfig
Use the no ipv6 address autoconfig command to disable the address autoconfig operation on the
management interface.
Default
Disabled
Command Modes
INTERFACE (management interface only)
Command
History
Usage
Information
• If more than two router advertisements are received, they are ignored and no new auto-configured
addresses are created. If one of the auto-configured addresses times out or is removed, then subse-
quent router advertisements will add the auto-configured address.
• If auto-configuration is enabled, all IPv6 addresses on that management interface are auto-config-
ured. Manual and auto-configurations are not supported on a single management interface.
• Removing auto-configuration removes all auto-configured IPv6 addresses and the link-local IPv6
address from that management interface.
• IPv6 addresses on a single management interface cannot be members of the same subnet.
• IPv6 secondary addresses on management interfaces across a platform must be members of the
same subnet.
• IPv6 secondary addresses on management interfaces should not match the virtual IP address and
should not be in the same subnet as the virtual IP.
ipv6 address
c e s
Configure an IPv6 address to an interface.
Syntax
ipv6 address {ipv6-address prefix-length}
To remove the IPv6 address, use the
no ipv6 address {ipv6-address prefix-length} command.
Version 8.3.12.0 Introduced on the S4810.
Version 8.3.12.0 Introduced on the S4810.