Command Reference Guide

70 | Control and Monitoring
www.dell.com | support.dell.com
Related
Commands
cam-audit linecard
e
Enable audit of the IPv4 forwarding table on all line cards.
Syntax
cam-audit linecard all ipv4-fib interval time-in-minutes
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
Command
History
Usage
Information
Enables periodic audits of software and hardware copies of the IPv4 forwarding table.
cam-audit stack-unit
Enable audit of the IPv4 and IPv6 forwarding table on all line cards.
Syntax
cam-audit stack-unit [all | ipv4-fib | ipv6-fib] interval time-in-minutes
Parameters
Defaults
Disabled
Command Modes
CONFIGURATION
banner exec Sets a banner to be displayed when you enter the EXEC Privilege mode.
banner login Sets a banner to be displayed after successful login to the system.
all
Enter the keyword all to enable CAM audit on all line cards.
ipv4-fib
Enter the keyword ipv4-fib to designate the CAM audit on the
IPv4 forwarding entries.
interval time-in-minutes Enter the keyword interval followed by the frequency in minutes
of the CAM audit.
Range: 5 to 1440 minutes (24 hours)
Default: 60 minutes
Version 7.4.1.0 Introduced on E-Series
all
Enter the keyword all to enable CAM audit on all line cards.
ipv4-fib
Enter the keyword ipv4-fib to designate the CAM audit on the
IPv4 forwarding entries.
ipv6-fib
Enter the keyword ipv6-fib to designate the CAM audit on the
IPv6 forwarding entries.
interval time-in-minutes Enter the keyword interval followed by the frequency in minutes
of the CAM audit.
Range: 5 to 1440 minutes (24 hours)
Default: 60 minutes