Command Reference Guide

692 | IPv4 Routing
www.dell.com | support.dell.com
Command Modes
EXEC
EXEC Privilege
Command
History
Example
FTOS#show ip int te 0/0
TenGigabitEthernet 0/0 is down, line protocol is down
Internet address is not set
IP MTU is 1500 bytes
Inbound access list is not set
Proxy ARP is enabled
Split Horizon is enabled
Poison Reverse is disabled
ICMP redirects are not sent
ICMP unreachables are not sent
FTOS#
brief
(OPTIONAL) Enter the keyword brief to view a brief summary of the
interfaces and whether an IP address is assigned.
linecard
slot-number
(OPTIONAL) Enter the keyword linecard followed by the number of the line
card slot.
C-Series Range: 0-7
E-Series Range: 0 to 13 on a E1200/1200i, 0 to 6 on a E600/E600i, and 0 to 5
on a E300
Note: This keyword is not available on the S-Series.
configuration
(OPTIONAL) Enter the keyword configuration to display the physical
interfaces with non-default configurations only.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.2 Supported on E-Series ExaScale E600i
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.0 Introduced for E-Series
Table 23-12. show ip interface Command Example Items
Lines Description
TenGigabitEthernet 0/0... Displays the interface’s type, slot/port and physical and line
protocol status.
Internet address... States whether an IP address is assigned to the interface. If one is,
that address is displayed.
IP MTU is... Displays IP MTU value.
Inbound access... Displays the name of the any configured incoming access list. If
none is configured, the phrase “not set” is displayed.
Proxy ARP... States whether proxy ARP is enabled on the interface.
Split horizon... States whether split horizon for RIP is enabled on the interface.