Command Reference Guide

IPv4 Routing | 683
Related
Commands
show ip cam linecard
c e
View CAM entries for a port pipe on a line card.
Syntax
show ip cam linecard number port-set pipe-number [ip-address mask [longer-prefixes] | index
index-number | summary | vrf vrf instance]
Parameters
Command Modes
EXEC
EXEC Privilege
Command
History
Example
FTOS#show ip cam linecard 13 port-set 0
Index Destination EC CG V C Next-Hop VId Mac-Addr Port
------ --------------- -- -- - - --------------- ---- ---------------- -------
Type Displays IP as the type of entry.
Address Displays the IP address(es) assigned to the host.
Table 23-6. show hosts Command Example Fields (continued)
Field Description
traceroute View DNS resolution
ip host Configure a host.
number Enter the number of the line card.
Range: 0 to 13 on a E1200/1200i, 0 to 6 on a E600600i, and 0 to 5 on a E300.
pipe-number Enter the number of the line card’s port-pipe.
Range: 0 to 1
ip-address mask
[longer-prefix]
(OPTIONAL) Enter the IP address and mask of a route to CAM entries for
that route only.
Enter the keyword longer-prefixes to view routes with a common prefix.
index
index-number
(OPTIONAL) Enter the keyword index followed by the CAM index number.
Range: depends on CAM size
summary (OPTIONAL) Enter the keyword summary to view a table listing route
prefixes and the total number of routes that can be entered into the CAM.
vrf instance (OPTIONAL) E-Series Only: Enter the keyword vrf followed by the VRF
Instance name to show CAM information as it applies to that VRF instance.
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.2 E-Series ExaScale E600i supported
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.9.1.0 Introduced VRF on the E-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.1.1.0 Introduced for E-Series