Command Reference Guide

IPv4 Routing | 663
c e s
Enable dynamic host-name to address resolution (that is, DNS).
Syntax
ip domain-lookup
To disable DNS lookup, use the no ip domain-lookup.
Defaults
Disabled.
Command Mode
CONFIGURATION
Command
History
Usage
Information
To fully enable DNS, also specify one or more domain name servers with the ip name-server
command.
FTOS does not support sending DNS queries over a VLAN. DNS queries are sent out all
other interfaces, including the Management port.
To view current bindings, use the show hosts command.
Related
Commands
ip domain-name
c e s
Configure one domain name for the switch.
Syntax
ip domain-name name
To remove the domain name, enter no ip domain-name.
Parameters
Defaults
Not configured.
Command Modes
CONFIGURATION
Command
History
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
ip name-server Specify a DNS server.
show hosts View current bindings.
name
Enter one domain name to be used to complete unqualified names (that
is, incomplete domain names that cannot be resolved).
Version 8.3.7.0 Introduced on S4810
Version 8.1.1.0 Introduced on E-Series ExaScale