Command Reference Guide

IPv4 Routing | 655
Parameters
Command Modes
EXEC Privilege
Command
History
debug arp
c e s
View information on ARP transactions.
Syntax
debug arp [interface] [count value]
To stop debugging ARP transactions, enter
no debug arp.
Parameters
Command Modes
EXEC Privilege
Command
History
all
Enter the keyword all to clear all TCP statistics maintained on all switch processors.
cp (OPTIONAL) Enter the cp to clear only statistics from the Control Processor.
rp1
(OPTIONAL) Enter the keyword rp1 to clear only the statistics from Route Processor 1.
rp2
(OPTIONAL) Enter the keyword rp2 to clear only the statistics from Route Processor 2.
Version 8.3.7.0 Introduced on S4810
Version 7.6.1.0 Introduced on S-Series
Version 7.5.1.0 Introduced on C-Series
pre-Version 6.2.1.1 Introduced on E-Series
interface
(OPTIONAL) Enter the following keywords and slot/port or number information:
• For a 1-Gigabit Ethernet interface, enter the keyword gigabitethernet
followed by the slot/port information.
• For the Management interface, enter the keyword managementethernet
followed by the slot/port information. The slot range is 0-1 and the port range
is 0.
• For a Port Channel interface, enter the keyword port-channel followed by a
number:
C-Series and S-Series Range: 1-128
E-Series Range: 1 to 255 for TeraScale and 1 to 512 for ExaScale.
• For a SONET interface, enter the keyword sonet followed by the slot/port
information.
• For a 10-Gigabit Ethernet interface, enter the keyword tengigabitethernet
followed by the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE followed by
the slot/port information.
• For a VLAN, enter the keyword vlan followed by a number from 1 to 4094.
count value
(OPTIONAL) Enter the keyword count followed by the count value.
Range: 1 to 65534
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.3.7.0 Introduced on S4810
Version 8.2.1.0 Support 4094 VLANs on E-Series ExaScale (prior limit was 2094)