Command Reference Guide

Interfaces | 617
Command Modes
EXEC
EXEC Privilege
Command
History
Usage
Refer to the figure below for an example screenshot, and the following table or a description
of the output fields.
For related commands, the Related Commands section, below, and the Debugging and
Diagnostics chapter for your platform at the end of this book.
Example
FTOS#show interfaces gigabitethernet 1/0 transceiver
SFP is present.
SFP 0 Serial Base ID fields
SFP 0 Id = 0x03
SFP 0 Ext Id = 0x04
SFP 0 Connector = 0x07
SFP 0 Transciever Code = 0x00 0x00 0x00 0x01 0x20 0x40 0x0c 0x05
SFP 0 Encoding = 0x01
SFP 0 BR Nominal = 0x15
SFP 0 Length(9um) Km = 0x00
SFP 0 Length(9um) 100m = 0x00
SFP 0 Length(50um) 10m = 0x1e
SFP 0 Length(62.5um) 10m = 0x0f
SFP 0 Length(Copper) 10m = 0x00
SFP 0 Vendor Rev = A
SFP 0 Laser Wavelength = 850 nm
SFP 0 CheckCodeBase = 0x66
SFP 0 Serial Extended ID fields
SFP 0 Options= 0x00 0x12
SFP 0 BR max= 0
SFP 0 BR min= 0
SFP 0 Vendor SN= P5N1ACE
SFP 0 Datecode = 040528
SFP 0 CheckCodeExt = 0x5b
SFP 1 Diagnostic Information
===================================
SFP 1 Rx Power measurement type = Average
===================================
SFP 1 Temp High Alarm threshold = 95.000C
SFP 1 Voltage High Alarm threshold = 3.900V
tengigabitethernet
For a 10G interface, enter the keyword tengigabitethernet followed by
the slot/port information.
fortyGigE For a 40G interface, enter the keyword fortyGigE followed by the slot/
port information.
Version 8.3.11.1 Introduced on Z9000.
Version 8.5.1.0 Added support for 4-port 40G line cards on ExaScale.
Version 8.1.1.0 Introduced on E-Series ExaScale.
Version 7.8.1.0 Output augmented with diagnostic data for pluggable media.
Version 7.7.1.0 Removed three fields in output: Vendor Name, Vendor OUI, Vendor PN.
Version 7.6.1.0 Introduced on C-Series and S-Series.
Version 6.5.4.0 Introduced on E-Series.